Product ID:SUPREME POWER STEERING FLUID, 65-953
MSDS Date:04/08/1997
FSC:9150
NIIN:00N090382
Status Code:A
MSDS Number: CHYKW

QUAKER STATE CORP

225 E JOHN CARPENTER FREEWAY
IRVING, TX 75062
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 800-562-5928

Cage: DO899

QUAKER STATE OIL REFINING CORPORATION

OIL CITY, PA 16301 US

Telephone: 814-676-7676

Cage: DO899

DISTILLATES (PETROLEUM), HYDROTREATED MIDDLE; (PETROLEUM

CAS: 64742-46-7

RTECS: JN9379645

Fraction By Weight: 0-100%

OSHA PEL N/K

ACGIH TLV: N/K

DISTILLATES, HEAVY NAPHTHENIC

CAS: 64741-53-3

RTECS: PY8034000

Fraction By Weight: 0-100%

OSHA PEL 300 PPM

ACGIH TLV: 300 PPM

MINERAL OIL, PETROLEUM DISTILLATES, LIGHT NAPHTHENIC;

CAS: 64741-52-2

RTECS: PY8037000

Fraction By Weight: 0-100%

OSHA PEL 300 PPM

ACGIH TLV: 300 PPM

ADDITIVES

Fraction By Weight: <1%

OSHA PEL N/K

ACGIH TLV: N/K

<1 PPM

CAS: 7440-43-9

RTECS: EU9800000

Fraction By Weight: <0.1%

OSHA PEL 0.2 MG/M3 DUST; Z-2

ACGIH TLV: 0.01 MG/M3 DUST

EPA Report Quantity: 10 LBS

DOT Report Quantity: 10 LBS

<1 PPM

CAS: 7439-92-1

RTECS: OF7525000

Fraction By Weight: <0.1%

OSHA PEL SEE 1910.1025

ACGIH TLV: 0.15 MG/M3 DUST

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

<1 PPM

CAS: 7440-38-2

RTECS: CG0525000

Fraction By Weight: <0.1%

OSHA PEL SEE 1910.1018

ACGIH TLV: 0.01 MG/M3, A1

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

INFLAMM BELOW ITS NORMAL FLASH POINT. HAZ COMBUST

RTECS: 9999999ZZ

MERCAPTANS, SULFIDES, OXIDES OF SULFUR, OXIDES OF

RTECS: 9999999ZZ

ALDEHYDES, CARBON MONOXIDE, CARBON DIOXIDE & OTHER

RTECS: 9999999ZZ

OXIDES OF ZINC, OXIDES OF CALCIUM,

RTECS: 9999999ZZ

MOLECULAR WEIGHT HYDROCARBONS.

RTECS: 9999999ZZ

ORAL & DERMAL TOX, BUT MINUTE AMTS

RTECS: 9999999ZZ

SEV PULM INJURY & POSSIBLY DEATH. LEAD APPEARS ON

RTECS: 9999999ZZ

HAZARDS. SEEK CONSULTATION FROM APPROPRIATE HEALTH

RTECS: 9999999ZZ

INFORMATION AND SAFE HANDLING AND EXPOSURE

RTECS: 9999999ZZ

ASPIRATION HAZARD IF SWALLOWED; TREAT

RTECS: 9999999ZZ

COMPLETED. ELIM ALL IGNIT SOURCES INCL FLARES,

RTECS: 9999999ZZ

DURING CLEAN-UP. SURFACES MAY BECOME SLIPPERY AFTER

RTECS: 9999999ZZ

DRAINAGE SYSTEMS OR OPEN WATER COURSES.

RTECS: 9999999ZZ

AVOID PRLNGD/RPTD BRTHG OF THIS MATL. AVOID

RTECS: 9999999ZZ

VENT. AVOID GENERATION OF OIL MISTS.

RTECS: 9999999ZZ

TO MAINTAIN AIR CONCENTRATIONS BELOW RECOMMENDED

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: EYES: MAY CAUSE IRRIT. SKIN:
MAY CAUSE IRRIT. PRLNGD AND/OR RPTD SKIN CONT W/THIS PROD MAY CAUSE
IRRIT/DERM. INGEST: MAY CAUSE NAUS, VOMIT & DIARR. SM AMTS OF PROD,
IF ASPIRATED INTO LUNGS MAY CAUSE MILD TO SEV PULM INJURY,
POSSIBLYDEATH. INHAL: LOW VAP PRESS MAKES INHAL UNLIKELY AT STD
TEMPS (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ: & PRESS. INHAL OF OIL MISTS/FUMES CAN
CAUSE IRRIT OF NOSE, THROAT & UPPER RESP TRACT. RPTD & PRLNGD
OVEREXP TO OIL MISTS MAY RSLT IN DROPLET DEPOSITION, OIL GRANULOMA
FORMATION, INFLAMM & IN CR INCIDENCE OF INFECTION. ACUTE TOX: BASED
ON SIMILAR MATLS, THIS PROD IS EXPECTED TO HAVE LOW ORDER OF ACUTE
(ING 13)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:EYES: FLUSH W/LG AMTS OF WATER FOR AT LST 15 MINS. GET MED
ATTN IF IRRIT DEVELOPS/PERSISTS. SKIN: WASH IMMED W/SOAP & WATER.
REMOVE CONTAMD CLTHG. GET MED ATTN IF SKIN DISORDER DEVELOPS.
LAUNDER CONTA MD CLTHG BEFORE REUSE. INGEST: GET IMMED MED
ATTN/ADVICE--DO NOT INDUCE VOMIT. INHAL: REMOVE TO FRESH AIR. IF
NOT BRTHG, APPLY ARTF RESP. GET MED ATTN IF SYMPS PERSIST. NOTES TO
PHYS: PULM (ING 17)

Flash Point:>310F,>154C
Extinguishing Media:WATER STREAM MAY SPREAD FIRE. USE WATER TO COOL
FIRE-EXPOSED CNTNRS & TO PROTECT PERSONNEL. DIRECT WATER SPRAY
(SUPDAT)
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:PROD IS NON-FLAMM PETRO DIST MIX. LIQ CAN
BURN UPON HEATING TO TEMPS @/ABOVE FLASH POINT. IF PROD IS HEATED
ABOVE ITS FLASH POINT IT WILL RELEASE FLAMM (SUPDAT)

Spill Release Procedures:STOP FLOW OF MATL, IF THIS IS W/OUT RISK.
ABSORB W/INERT ABSORB SUCH AS DRY CLAY, SAND/DIATOMACEOUS EARTH,
COMMERCIAL SORBENTS/RECOVER USING PUMPS. PERSONS NOT WEARING PROT
EQUIP SHOULD BE EXCLUDED FR OM AREA OF SPILL UNTIL CLEAN-UP HAS
BEEN (ING 18)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE THIS MATL IN OPEN/UNLBLD
CNTNRS. DO NOT STORE NEAR HEAT, SPKS, OPEN FLAME/STRONG OXIDIZING
AGENTS.
Other Precautions:"EMPTY" CNTNRS RETAIN PROD RESIDUE (LIQ AND/OR VAP) &
CAN BE DANGEROUS. DO NOT PRESSURIZE, CUT, WELD, BRAZE, SOLDER,
DRILL, GRIND/EXPOSE SUCH CNTNRS TO HEAT, FLAME, SPKS, STATIC
ELECTRICITY/OTHER SOUR CES OF IGNIT; THEY MAY EXPLODE.(ING 21)

Respiratory Protection:IF MIST IS GENERATED (HEATING, SPRAYING) AND
ENGINEERING CONTROLS ARE NOT SUFFICIENT, WEAR NIOSH APPROVED
ORGANIC VAPOR RESPIRATOR SUITABLE FOR OIL MIST.
Ventilation:USE GEN VENT & USE LOC EXHST, WHERE POSS, IN
CONFINED/ENCLOSED SPACES. ADDNL AREA VENT/LOC EXHST MAY BE REQD
(ING 23)
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EYE WASH & DELUGE SHOWER . WEAR
OIL-IMPERVIOUS GARMENTS IF CONT IS UNAVOIDABLE.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING. USE GOOD
HYGIENE WHEN HANDLING PETROLEUM PRODUCT.
Supplemental Safety and Health
FL PT: >310F,>154C BASED ON FORMULATION. EXTING MEDIA: OR FOAM MAY
CAUSE FROTHING & SPATTERING. IF LEAK/SPILL HAS NOT IGNITED, USE
WATER SPRAY TO DISPERSE VAPS & TO FLUSH SPILLS AWAY FROM EXPOS.
EXPLO HAZ: VAPS WHICH CAN BURN IN OPEN/BE EXPLO IN CONFINED SPACES
IF EXPOSED TO IGNIT SOURCE. MISTS/SPRAYS MAY BE (ING 8)

Vapor Density:HVR/AIR
Spec Gravity:0.90-0.93
Evaporation Rate & Reference:NOT KNOWN
Solubility in Water:NEGLIGIBLE
Appearance and Odor:LIGHT YELLOW-AMBER LIQUID. PETROLEUM ODOR.
Percent Volatiles by Volume:NIL

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS (PEROXIDES, CHLORINE, STRONG ACIDS).
Stability Condition to Avoid:AVOID FORMATION OF MISTS.
Hazardous Decomposition Products:DECOMP PRODS MAY INCL HYDROGEN
SULFIDE, ALKYL MERCAPTANS, SULFIDES, OXIDES OF SULFUR, OXIDES OF
PHOSPHORUS, (ING 11)

Waste Disposal Methods:DISPOSE OF WASTE MATERIAL ACCORDING TO LOCAL,
STATE, FEDERAL, AND PROVINCIAL ENVIRONMENTAL REGULATIONS. MATERIAL
SHOULD BE RECYCLED IF POSSIBLE.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.